Type KR3000
Which shelf support fits me?
Type KR3000 Top seller
Cantilever rack type KR3000
- Rack height 2m - 4m
- single + double sided cantilever rack with freely adjustable arms in a 5cm grid in height
- connection of cantilever uprights is made by cross and diagonal braces
- Upright profile is screwed to the base
Easy to assemble- Best price
- All parts included
Easy to assembleAssembly instructions
Quality of our products
Voluntary testing of our cantilever racks
In order to subject ourselves to external quality tests, we have our products voluntarily tested every year.
The racks are tested for load, rigidity and stability.
The maximum shelf and bay loads are listed on the load plates included in the delivery.
Finishes
Painted for indoor use
Single + double sided versions
Click here for prices and product overview
Hot-dip galvanized for outdoor use
Hot-dip galvanized racks for outdoor use
Overview uprights cantilever rack KR3000
One-sided upright
Stability due to T-beam
Double sided upright
2 different depths - 50cm arm depth (80cm foot depth) and 100cm arm depth (130cm foot depth)
Complete rack stand consists of a double C-profile and the foot part in the form of a T-beam (foot). The upright profile is screwed on the foot.
Stand
Versions + mass
Stand load
One-sided max. 1500KG
Double sided max. 3000KG
Loads are valid with evenly distributed load
Mounting stand
Load on foot section
The area of the foot part of the cantilever rack can be loaded infinitely.
Technical information
Fastening in the floor
Required parts
:assembled shelf, bolt anchor
- Drill holes: 12mm ∅, 100mm deep.
- Blow out holes
- No floor bracket needed. Holes are already integrated / pre-drilled in the base part.
- Drive in bolt anchor with base holder - nut should be flush with thread
- Tighten anchor firmly
- After tightening, the marking in the thread must not be visible!
Please note:
The bolt anchors must be fastened professionally.
Our in-house assembly team will gladly take over the professional assembly of your shelves.
Axle dimensions
- The axle dimension describes the width of a rack field, as well as the distance between two uprights.
- We offer two different axle dimensions in the widths 100cm & 150cm.
- The different axis dimensions can be freely combined with each other
- Configure your cantilever rack individually with your desired bay lengths. Our racks can be extended at any time, due to the modular construction.
Assembly struts
Technical information
Assembly of cross and diagonal braces
Required parts:
diagonal brace, cross brace, hexagon bolt, hexagon nut, washer
- The assembly of the cross and diagonal braces is done by means of M10*80 hexagonal bolts, M10 washers, M10 nuts and retaining plates directly on the upright profile
- with a 17mm open-end wrench and a ratchet with 17mm nut the assembly is done in a few minutes
Diagonal braces + cross braces are used for stiffening between the uprights and increase stability
Cantilever arms
Max. Load per arm = 500kg
Arm is suitable for one-sided and double-sided design.
Arm load
- Total load per cantilever armMaximum
500kg with evenly distributed load
Assembly of cantilever arms
Technical information
Assembly of the cantilever arms
1. bring cantilever arm to desired height
2. hook in locking pin
3. attach safety pin
4. attach roll-off protection
Cantilever arm accessories
Cantilever arm separator
For dividing the cantilever arms into separate compartments
Cantilever rack Rubber strip
Protects against scratching and slipping
Examples of use
Optimal for long goods
